Welcome to the fan community of Transport Fever and Train Fever, the economic simulators of Urban Games. The community is free for you to share and inform yourself about the game. We cultivate a friendly and objective interaction with each other and our team will be happy to answer any questions you may have.
Registration and use is of course free for you.
We wish you a lot of fun and hope for active participation.
The Team of the Transport-Fever Community
For a long time I wanted to have the MAN 15t A1.1 Multi designed by Cubus as a running vehicle in TF2. After a steep leaning curse I got my first version as an asset.
Now working to get it running. Almost there. But still I miss something. When buying it in a depot it is missing its wheels. It will float over the road 
When placing it as an asset, it has its wheels attached.
I used the ModelEditor and some examples to configure. What am I missing?
Can u send a picture from the mod in ME with "render debug info" enabled
I made a screenshot as requested.
You have "Render Debug info" enabled? Normally the axels and wheels should be dislayed like tihs
Otherwise is the Origin of the wheels and axles not correct. The Origin for the wheels must be in the middle of the tires and for the (rear)axles in the middle of the axles, (as you can see in my picture).
Same settings as you. See no origin for the axis.
It should look like this?
Found in Blender how to set an origin for the wheels.
Yes this should do it.
Done it 
Multi is running.
Now some more detailing and variants. Before moving to the other Cubus MAN Kat1 vehicles.
Blender has a modifier for Faces called "Shade Flat." You should use it for faces like this one, which are truly flat, otherwise, they'll shine like in the picture. Alternatively, you can select the edges and set them to "mark sharp." This will split them up during export (with the edge split modifier set and unticked "split angle"), which has the same effect.
Or you can use the "Edge Split Modifier" with ticked "Split angle" for the entire mesh and set it to, say, 85°. Then the rounded surfaces will remain round, but everything close to 90° will be split. However, you'll always have to double-check after exporting to make sure it still looks as expected.
The first method is safer, as you decide what should be flat and what should be split. The latter is for lazy people who don't want to go through every edge. But it works fine in most cases.
Thanks for the tip.
It turned out I had to use Shade flat on several places.
It looks even better now.
Yes, I agree. It looks better than before, keep it up. That looks promising.
a hooklift MAN 8x8 - i love it!
Progress
15t Multi (Flatbed / no flatbed / loaded with grenades)
15t Truck (open / covered )
7t Kipper (empty / filled with sand)
7t FSB (empty / loaded with ponton and trailer loaded with boot)
All in running condition.
Now also a ponton bridge which can be used by vehicles. Different sizes can be selected.
Latest update
6x6
8x8
8x8 Multi
Next will continue working on Military - Engineers including a usable pontonbridge
Display MoreLatest update
6x6
8x8
8x8 Multi
wow...amazing update, it looks incredible 
job well done mate
looking forward to your next update...
Next Update = First Release?
du hast recht, die Mod ist anscheinend noch gar nicht veröffentlicht, was sehr schade ist 
Small update
Was having too much fun on Sketchfab finding more military vehicles to get them in running condition for TF2. Like the Strykers and Boxer.
Now it is time to get focused again and make them ready for publishing.
